How to access router for mac
The SSID is the name that identifies your wireless router. When disabled, the router settings can still be changed using any computer that is directly connected to the router using a network cable. With routers that support this option, it is often disabled through the Administration section. If you never plan on remotely administrating your network (e.g., wirelessly connecting to the router), we recommend disabling remote administration.
When enabled, remote administration allows anyone close enough to your router to view or change your router settings. Using WEP is still better than no security at all. However, for compatibility with some older devices, such as gaming consoles, TiVo, and other network devices, WEP may be the only security option possible to use. We recommend WPA or WPA2 security since it is more secure than WEP. Many routers today offer two or three different security schemes: WEP, WPA, and WPA2. With access to the router setup, a person could change your router settings, including viewing any security keys.
#HOW TO ACCESS ROUTER FOR MAC PASSWORD#
If the default password is used, it can be easily guessed and give someone access to your router. Make sure the router password is not using the default password. After enabling security on the router, any wireless device must have the key to connect to your network. The, enter a passphrase to generate the keys. Select the wireless security method of either WEP, WPA, or WPA2 (we suggest WPA or WPA2, which is mentioned further down on this page). The picture shown here is an example of a Linksys router set up in the Wireless Security section. To enable security, open your router setup screen and look for a Wireless Security section.
In other words, if anyone is close enough to your router, they could connect to your network. If you have never been prompted for a key, password, or passphrase when connecting to your wireless network, it is an unsecured network. Check your router's documentation for exact instructions. Because all routers are different we cannot provide specific steps for every router.